High Wear Resistant Rubber Planetary Cement Mixer , High Speed Operation Cement Concrete Mixer

High Wear Resistant Rubber Planetary Concrete Mixer High-Speed Operation PMC50

Hydraulic System Maintenance Instruction

1.Strictly follow the instruction to check the condition of the pump before use if the hydraulic pump has stopped for a long time;

2. Replace the oil and oil filter after running the first 100hours, then replace the oil or oil filter after 1000 hours running. From then on, replace oil or oil filter every 2000 hours.

3. When replace oil, clean oil tank and working components with new oil firstly then pour new oil

4. Check the bolts regularly and assure they are not loosen ;

The performance characteristics of Mixer

1. Reasonable design and performance optimization of the whole machine

2. Convenient use and maintenance;

3. Firm and reliable, life factory;

4. Good mixing quality and high efficiency

5. Convenient operation and fast discharging speed

6. Low energy consumption and low noise

The use of mixer

1. Before use, the machine should have an empty test. Before the test machine, the firmness of all the connecting parts of the machine table shall be checked first, especially if the bearing part is loose during transportation. Close the main switch, access the power supply, run the empty test machine.

2. Empty machine test. The mixer can only be put into production without abnormal sound, high heat of bearing gear, etc.

3. If abnormal vibrations or strange sounds are detected during use, stop the mixer and give a thorough inspection.

4. The load should not be too large. It is generally measured by the load of the motor. The load current of the 380V motor when stirring the material should not exceed 6 amps. If it exceeds the load, the stirring capacity should be reduced immediately.

5. Managers should be familiar with the technical performance, internal structure, control structure, and operating principle of the mixer. Do not leave the workplace during operation to prevent malfunctions and damage to mechanical parts, so as to ensure safe production.

Principle of Motion: Mixing with no hidden corners in the mixing pan by installing mixing tools and scraper tools on a specially designed drive system. The mixing track as follows.